AMCI provides a line of pre-assembled and tested cables to easily connect our controllers to our resolver based transducers and encoders. All AMCI transducer cables are made from a Belden® brand or equivalent cables with noise resistant individually shielded twisted pairs. These cables, which can be ordered in any five foot increments, come with the transducer’s connector soldered onto the cable. The other end of the cable has tinned pig-tailed wires that can easily be pulled through a conduit and attached to your controller’s terminal block connector. AMCI also offers pre-assembled cord sets for our PLC-based network products with an Ethernet interface. Communication cables are available in 5 meter lengths for Ethernet connections and they come equipped with an M12 connector on one end and RJ45 plug on the other end. Power cables are available too, but in 2 meter lengths made out of 5 conductor 22 AWG wire (heavy gauge).